Educational tool. Not for certification, audits or official GHG reporting. Use certified values and your certification scheme's rules.

Calculator

Calculation mode

Inputs

Source: Annex V Parts A and D, Directive (EU) 2018/2001, consolidated text 02018L2001-20240716. Disaggregated default values in gCO2eq/MJ.

Emissions added, gCO2eq/MJ
Emission savings subtracted, gCO2eq/MJ

Sets the minimum saving under Art. 29(10)(a)–(c): 50% (in operation on or before 05.10.2015), 60% (06.10.2015–31.12.2020), 65% (from 01.01.2021).

How to read the result

Bio content is not GHG savings

Bio content says where the carbon in a fuel comes from. GHG savings say how much less greenhouse gas the whole supply chain emits per megajoule than the fossil fuel comparator of 94 gCO2eq/MJ. These are two different questions.

Growing or collecting the feedstock, processing it and transporting the fuel all cause emissions. So a fuel that is 99% bio by energy, made at 20 gCO2eq/MJ and blended with 1% fossil, comes out at 20.74 gCO2eq/MJ and saves 77.9%, not 99%. The blend mode above starts with exactly this example.

The feedstock matters most. With Annex V default values, biodiesel from waste cooking oil saves 84%, while biodiesel from rape seed saves 47%, mainly because a waste carries no cultivation emissions.

E = eec + el + ep + etd + eu − esca − eccs − eccr
Savings = (94 − E) / 94

Annex V Part C point 1(a) and point 19 (fossil fuel comparator EF(t) = 94 gCO2eq/MJ).

What each term means

Good to know

  • Default values and land-use change. The Annex V default values may only be used when there are no net emissions from land-use change, that is when el is zero or below.
  • ETBE and TAEE. The renewable part of ETBE and TAEE takes the value of the ethanol production pathway used.
  • Thresholds of 70% and 80%. The thresholds in Art. 29(10)(d)–(h) apply to electricity, heating and cooling from biomass fuels, not to transport biofuels. This tool checks Art. 29(10)(a)–(c) only, which RED III left unchanged.
  • Blends. The minimum saving applies to the biofuel itself. The blend mode shows the average of a mix and is there to illustrate the difference between bio content and savings.

About

Built by Unaiz Ahmed Khan, chemical engineer in Berlin. Four years leading production and procurement at a renewable fuels producer, where he raised the GHG savings of the company's fuels to 78% (RED II methodology) by sourcing bio-based feedstocks. Environmental Protection Officer (TÜV Rheinland) and IPMA Level D certified project manager, both 2026.